Hi Again….
Per DLX suggestion I tried some mattresses at the local Bowles the problem is they all are Zoned (5’3 115 pounds) Below are specs of a couple I felt ok on..
I also talked to someone’s at Beloit about their hybrid’s the restore doesn’t appear to use zoned and uses Talalay… problem no return since I am a 7 hour drive. I contacted them originally a few weeks ago set on ordering an old school flippable because I am so frustrated and that’s when the rep suggested their hybrid..
I am actually considering the DLX latex hybrid at the point thinking the bit of firmness would be best for my problematic back…. thoughts?
I tried a mattress at Bowls 768 8" TPS Tri-Zone Quad Coil the Springhouse is this a 14.5 gauge? Do I need a 15.5 gauge? They also have a 3 zoned Bolsa coil in the hybrid serene. Am I right in thinking this Texas quad coil is superior yet too firm?
The Governor felt good on the back but long term not sure about side. Bowles doesn’t offer trials and they have mandatory add ons like mattress topper which kinda gives me iffy feelings. The latex is not identified Dunlop or Talalay but assuming Dunlop and thinking the Governor may be too firm for side.
I am a combo primary back then side sleeper here are the specs… not sure this would work long term for back side sleep
I am 5ft 3 inch 115 pounds
14" Mattress profile
2" 7-Zone 3.3 Density Soft Latex
1" 2.5 Density Serene® Foam
.75" 1.5 oz. fiber comfort support layer
ELS-Enhanced Lumbar Support
768 8" TPS Tri-Zone Quad Coil
1" 1.8 Firm Foam Base Layer
The Governor
- Triple Hybrid Plush Top, No Flip Construction
- Licensed Performance Fabric quilted to 1 1/2" 1.5 Density Foam;
- 14" Mattress profile
- 1" 7-Zone 3.8 Density Firm Latex
- 1" 2.5 Density Serene® Foam
- 1" 3 lb. Active Response Foam
- .75" 1.5 oz. fiber comfort support layer
- ELS-Enhanced Lumbar Support
- 768 8" TPS Tri-Zone Quad Coil
- 1" 1.8 Firm Foam Base Layer
Beloit has a restore mattress that uses Talalay comfort layer and their own spring system
Anyhoo having surgery in early March so hoping to nail this down by Januaryish 